When you read from processing you are only reading one byte.
![]()
It is written Arduino.jar and so, Ive got every time this error message. I have renamed the file in arduino.jar and the library works well. The guys of the arduino project should corred this in the processing-arduino-0017.zip file. I would very much appreciate if any of you can guide me on below project. Using two pins 9 10 to turn on two light bulbs (making the pins HIGH) and turn off them (making the pins LOW). If you want two Arduinos (two different COM ports) to connect to Processing that is another discussion. Go to the Arduino.cc site and find references there. Now plug-in and remove all your Arduini, in turn and together. It depends on the socket on the PC, not the individual board and is very annoying. You will have to make sure you use the same socket for the same board each time. Processing Serial Communication Code Formatting MenuI was not aware of code formatting menu. Now I know. I also corrected the case. Processing Serial Communication Serial Communication BetweenThanks once again Regarding serial communication between Processing and Arduino, I am little bit familiar with that, and I was not having any issue as I have single load (light bulb). I can easily pass serial command from the processing to the arduino board. ![]() How arduino knows that I want to turn the second pin HIGH or LOW (second serial communication from processing to Arduino) I have Arduino Uno board. Richard, mine is a Arduino board (dont think fake Chinese one) Any help will be appreciated. The programmer emulates an STK500 on a virtual serial port, making.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |